Buyers routinely ask us for "a CE certified helmet" as if it were a single thing. It is not. The standard a helmet is tested to depends entirely on what the helmet is for, and the results are not transferable between categories.
- Top impact absorption
- Retention system strength
- Field of vision and coverage
- Top impact absorption
- Retention system strength
- Defined coverage zones
- Top, front, rear and side impact
- Penetration resistance
- Strap designed to release under load
- Top impact absorption
- Penetration resistance
- Shell rigidity
EN 1078 - bicycle, skateboard and roller sports
EN 1078 is the European standard for helmets worn by cyclists, skateboarders and roller skaters. It covers three main areas:
- Impact absorption - a drop test onto a fixed anvil, with limits on how much force may pass through to the headform.
- Retention system - the strap and buckle must keep the helmet on the head during a dynamic pull test.
- Field of vision and coverage - the shell must not block sight lines, and must cover a defined area of the head.
A helmet that passes EN 1078 carries the CE mark. That CE mark refers to that specific model, in that specific size range, as tested by that specific laboratory. It does not transfer to a different shell shape.
16 CFR Part 1203 - the US CPSC bicycle standard
The American equivalent is 16 CFR Part 1203, enforced by the Consumer Product Safety Commission. It tests much the same physical properties, but the pass criteria, drop heights and coverage zones are set independently of the European standard.
This matters in practice: a helmet built to EN 1078 is not automatically compliant with 16 CFR 1203. The shell geometry, liner density and strap anchoring often need to change. If you sell into both the EU and the US, you need test reports against both standards - not one report and an assumption.
EN 12492 - mountaineering and climbing
Climbing helmets face a different threat model. A falling rock can strike the top of the head, but a climber can also swing into a wall, so lateral impact matters too. EN 12492 therefore adds:
- Front, rear and side impact tests, not just top impact
- Penetration resistance against sharp objects
- A chin strap designed to release under extreme load, so a snagged helmet does not hang the wearer
That last point is the reason a climbing helmet is deliberately not designed to be as hard to remove as a bike helmet. The two standards conflict on purpose.
GB 2811 and GB/T 41526 - the Chinese national standards
GB 2811 governs industrial safety helmets - the hard hats worn on construction and industrial sites. GB/T 41526 covers sports helmets. Both are relevant to buyers sourcing from China, and both produce test reports in a different format from Intertek's EN or CPSC reports.
Do not ask a supplier "is this certified". Ask: which standard, for which model number, tested by which laboratory, and can I see the report. A report that names a different model than the one you are buying is not evidence for your product.
Why model numbers matter more than certificates
When a factory holds reports for model S-172 but is selling you model R-15, the report does not cover your purchase - even if the two helmets look similar. Both names appear on paper, and a customs officer, an insurer or a retailer's compliance team can tell the difference.
Always match the model number on the test report to the model number on your purchase order and packaging artwork. If the supplier cannot do that, the certification claim is decorative.
We list our own testing status per category and per model, with the exact model numbers each report covers. See the collections or ask us for the reports.